Accessing all units in the Editor
Posted: Thu Aug 27, 2015 4:12 pm
The units are divided into two lists. By default, selecting side0 for unit placement in the editor only shows the side0 unit list, and selecting side1 only shows the side1 unit list. Most units have duplicate versions in each list, but some special national units only exist in their nation's default side list.
The latest version of the engine (as used in P&S Campaigns) allows you to hold down the SHIFT key when you select Side0 for unit placement. The list will then show all of the units - there will be lots of duplicates, but you will have access (for Side0 unit placement) to the ones that are normally only shown for Side1.
Similarly SHIFT Side1 allows you to select from both sets of units for Side1 unit placement.
The latest version of the engine (as used in P&S Campaigns) allows you to hold down the SHIFT key when you select Side0 for unit placement. The list will then show all of the units - there will be lots of duplicates, but you will have access (for Side0 unit placement) to the ones that are normally only shown for Side1.
Similarly SHIFT Side1 allows you to select from both sets of units for Side1 unit placement.