Accessing all units in the Editor

Moderators: rbodleyscott, Slitherine Core, Gothic Labs

Post Reply
rbodleyscott
Field of Glory 2
Field of Glory 2
Posts: 22066
Joined: Sun Dec 04, 2005 6:25 pm

Accessing all units in the Editor

Post by rbodleyscott » Thu Aug 27, 2015 4:12 pm

The units are divided into two lists. By default, selecting side0 for unit placement in the editor only shows the side0 unit list, and selecting side1 only shows the side1 unit list. Most units have duplicate versions in each list, but some special national units only exist in their nation's default side list.

The latest version of the engine (as used in P&S Campaigns) allows you to hold down the SHIFT key when you select Side0 for unit placement. The list will then show all of the units - there will be lots of duplicates, but you will have access (for Side0 unit placement) to the ones that are normally only shown for Side1.

Similarly SHIFT Side1 allows you to select from both sets of units for Side1 unit placement.
Richard Bodley Scott

Image

macdonncadh
Corporal - Strongpoint
Corporal - Strongpoint
Posts: 60
Joined: Fri Apr 24, 2015 1:30 am

Re: Accessing all units in the Editor

Post by macdonncadh » Fri Aug 28, 2015 12:34 am

Far out...

Post Reply

Return to “Scenario Design”